RADR Wireless Remote Assembly Docs

Assembly documentation package for the RADR wireless remote.

Assembly Package

• PCB Overview
• Bill of Materials
• Assembly Guide

Safety first

RADR contains a 3.7 V 800 mAh lithium polymer (LiPo) battery, which stays connected for most of the build. The build also uses a rasp, isopropyl alcohol, a razor blade, and a hot glue gun. Read the safety notes at each step of the assembly guide.

• If a battery swells, leaks, gets hot, or smells, stop charging or using it. If it is safe to do so, move it to a non-flammable surface, away from anything that can burn. Do not use it again. If it smokes or catches fire, leave the area and call emergency services.
• Battery & charging: charge the finished remote through its USB-C port.
• RADR controls other devices. Before you use it with an OSSM, follow the OSSM Pre-play Safety Checklist.

Product Overview

RADR is a wireless remote built around a populated RADR PCB assembly, 2.0 inch SPI display, 800 mAh LiPo battery, printed front and back housings, printed buttons, printed power switch cover, printed rotary knob, weather stripping, and tri-lobe enclosure screws.

Product Dimensions and Materials

Known material and part notes:

• Housing: FDM-printed RADR front and back housing.
• Display: 2.0 inch 14-pin SPI LCD display.
• Battery: 3.7 V 800 mAh LiPo battery.
• Fasteners: BC-0408LTFB tri-lobe screws.
• Cushioning: 2.5 cm piece of weather stripping installed on the PCBA.